EasyManuals Logo
Home>AudioCodes>Gateway>MSBG Series

AudioCodes MSBG Series User Guide

AudioCodes MSBG Series
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #24 background imageLoading...
Page #24 background image
Mediant 1000 Analog & Digital
Fast Track Guide 24 Document #: LTRT-83501
3. Connect telephone B to Port 3 of module 1.
4. Offhook telephone A, and then dial 201 (Port 1 of module 2 - FXO); you’ll receive a dial tone.
This dial tone is the equivalent of the PBX’s dial tone.
5. Dial 103 (the number configured for telephone B connected to Port 3 of module 1 - FXS);
telephone B rings (the FXO module’s Port 1 outpulses digits).
6. Offhook telephone B and test the line for voice.
3.5.3.3 Making a Mediant 1000 to MP-104 FXS Call
The following setup requires two telephones (A and B), two RJ-11 cables, and an MP-104
gateway. Note that the Mediant 1000 and the MP-104 must be in the same subnet.
¾ To make a Mediant 1000 to MP-104 FXS call, take these 5 steps:
1. In the Mediant 1000 ‘Tel to IP Routing Table’, in Row 3, in the ‘Dest. Phone Prefix’ field,
enter 30. In the ‘Source Phone Prefix’ field, enter an asterisk wildcard (*). In the ‘Dest. IP
Address’ field, enter the IP address of the MP-104; every call whose destination number
starts with 30 is routed to the MP-104.
Figure 3-8: Mediant 1000 'Tel to IP Routing' Screen
2. In the MP-104 ‘Endpoint Phone Number Table’ screen, in Row 1, in the ‘Channel(s)’ field,
enter 1-4, and the first phone number, for example, 301, corresponding to channel 1, in the
‘Phone Number’ field (shown in Figure
3-6 on page 22). The phone numbers 302, 303, and
304 are automatically assigned (in sequence) to corresponding channels.
Figure 3-9: MP-104 'Endpoint Phone Number Table' Screen
3. Connect the RJ-11 cable of telephone A to Port 1 of module 1 (where module 1 is an FXS
module) on the Mediant 1000. Connect the RJ-11 cable of telephone B to Port 1 on the MP-
104 gateway.
4. Offhook the receiver of telephone A (whose number you defined as 101), and then dial 301;
telephone B connected to the MP-104 rings.
5. Offhook telephone B and test the line for voice.
Note that to make a call from telephone B on the MP-104 to telephone A on the Mediant 1000,
you must define the internal routing table on the MP-104.

Table of Contents

Other manuals for AudioCodes MSBG Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the AudioCodes MSBG Series and is the answer not in the manual?

AudioCodes MSBG Series Specifications

General IconGeneral
BrandAudioCodes
ModelMSBG Series
CategoryGateway
LanguageEnglish

Related product manuals