This equipment has been tested and found to comply with the limits for a Class 13 digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guaran-tee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which con be determined by turning the equipment off and an, the user is encouraged to try to
correct the interference byone or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver
Connect the equipment into an outlet an a circuit different from that to which the receiver is connected. –
Consult the dealer man experienced technician for help.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth far an uncontrolled environment This
equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
Information for Users on Disposal of Old Equipment [European Union]
This symbol indicates that the electrical and electronic equipment should not be disposed as general
household waste at its end-of-life Instead, the product should be handed over to the applicable collection point for the
recycling in accordance with your national legislation.
By disposing of this product correctly, you will help to conserve the environment and human health that could
otherwise be caused by inappropriate waste handling of this product. For more information about collection point and
recycling of this product, please contact your household waste disposal service or the shop where you purchased the
product. Penalties may be applicable for incorrect disposal of this waste, in accordance with national legislation.
[Other Countries outside the European Union]
If you wish to dispose of this product, please do so in accordance with applicable national legislation or other rules in
your country for the treatment of old electrical and electronic equipment.
Audioengine
Home Music System
© 2020 Audioengine, LLC. All Rights Reserved.
Audioengine and Audioengine Al are trademarks of Audioengine. The Bluetooth name and the Bluetooth trademarks
are owned by Bluetooth Sib, Inc. and are used by Audioengine under license.
The apt(. mark and logos are registered trademarks of Qualcomm Technologies International, Ltd.
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc.
A1 Quick Setup
Step 1: Connect the included speaker wire from the A1 left (powered) speaker to the right (passive) speaker,
observing proper polarity to each speaker connector.
Step 2: Verify that the volume/power knob on the rear panel of the left speaker is in the OFF position by rotating the
knob until it clicks off..
To Next Page
Loading...
Need help?
General
