Installation Instructions
SAFETY INSTRUCTIONS FOR INSTALLATION
Not following the installation instructions can lead to serious injury or equipment failure. Ensure you follow the steps
carefully to avoid complications.
Site Requirements
a.
Look at the ceiling:
i.
Is it plastered? The opener is mounted to a perforated angle which MUST be securely fastened to a
structural support.
You will need to locate the structural beams in the ceiling which are generally
400mm apart.
ii.
Does it have exposed beams? The opener is mounted to a perforated angle which must be
securely fastened to a
structural support like the exposed beams. You may need to install a 40mm
thick board (not supplied) between structural
supports.
b.
Look at the wall above the garage door.
i.
Is it brick? The wall bracket MUST be securely fastened to the wall with suitable screws and ensure it does
not move.
ii.
Is it timber? The wall bracket MUST be securely fastened
to a structural
support. You may need to install a 40mm thick
board (not supplied) between structural supports to fasten
the wall bracket to.
Test the following before commencing installation:
a.
The door MUST BE in good operating condition.
b.
Manually move the door up and down, the door should
move freely without binding or sticking.
c.
The maximum force required to move the door should not
exceed 15kg.
d.
Lift the door to about halfway. When released, the door should
stay in place.
Setup Requirements
a. The opener must be installed in a dry location, protected
from weather. Moisture and corrosion damage is not
covered by warranty.
b. The opener requires properly earthed 3 pin single phase
power within an arm’s length of the door motor / opener
and at a suitable height.
c. Requires a MINIMUM HEADROOM of 57mm between the
highest point of the door’s travel and the ceiling.
To Next Page
Loading...
Need help?
General