Installation (steel track)
Fig. 6
1.
Fix the wall bracket to the wall 2cm-10cm over the shaft or intermediate bracket
(depending on the
actual installation space).
2.
Fix the steel track to the wall bracket with axis pin. (Fig. 6)
3.
Mount the garage door opener to the track by U bracket.
4.
Attach the opener onto the ceiling by the hanging bracket.
NOTE: Make sure the track is horizontal and vertical to the shaft. Make sure the connection of
hanging bracket and
ceiling is firm enough.
5.
Attach the clutch cord.
6.
Release the clutch, try to open and close the door by hand. Make sure there is no
resistance between
door panel and track.
7.
Attach the door bracket to the door.
8.
Attach the bent arm to the straight arm with the bolts provided.
9.
Plug in the power cord and turn power on to the motor unit.
To Next Page
Loading...
Need help?
General