J-50
FX/FXH/FXL Series
Features
Ordering information
DIN W72×H72, W48×H96, W144×H72mm counter/timer
● 36 input modes and 20 output modes
● Counting speed : 1cps/30cps/2kcps/5kcps
● Selectable voltage input(PNP) or No voltage input(NPN)
● Addition of Up/Down input mode
● Wide range of power supply
: 100-240VAC 50/60Hz, 12-24VAC/DC(Option)
● Selectable Counter/Timer by internal DIP switch
● Various time range
● Built-in Microprocessor
Specifi cations
Model
Single preset FX4 FX6 FX4H
--
Dual preset FX4-2P FX6-2P FX4H-2P FX4L-2P FX6L-2P
Totalizer(Indicator) FX4-I FX6-I FX4H-I FX4L-I FX6L-I
Digit 4digit 6digit 4digit 4digit 6digit
Digit size W8×H14
mm
W4×H8
mm
W6×H10
mm
W8×H14
mm
Power supply 100-240VAC 50/60Hz, 12-24VAC/DC(Option)
Allowable voltage range 90 to 110% of rated voltage
Power consumption
• Indicator : Approx. 6VA(240VAC 60Hz), Approx. 2.7W(24VDC), Approx. 5.8VA(24VAC 60Hz)
•Single preset : Approx. 7VA(240VAC 60Hz), Approx. 3.3W(24VDC), Approx. 6.8VA(24VAC 60Hz)
•Dual preset: Approx. 8VA(240VAC 60Hz), Approx. 3.8W(24VDC), Approx. 7.6VA(24VAC 60Hz)
Max. counting speed for CP1, CP2 Selectable 1cps/30cps/2kcps/5kcps by internal DIP switch
Min. input
signal width
RESET input
Approx. 20ms
INHIBIT input
Input
CP1, CP2 input
(INHIBIT)
Input logic is selectable
[Voltage input] Input impedance : 5.4kΩ, "H" level : 5-30VDC, "L" level : 0-2VDC
[No-voltage input] Impedance at short-circuit : Max. 1kΩ, Residual voltage at short-circuit : Max. 2VDC,
Impedance at open-circuit : Min. 100kΩ
RESET input
One-shot output time
• Single preset type - 0.05 to 5sec.
• Dual preset type - 1st. output 0.5sec. fi xed, 2st. output : 0.05 to 5sec.
Control
output
Contact
Type Single preset type : SPDT(1c), Dual preset type : 1st output SPDT(1c), 2nd output SPDT(1c)
Capacity 250VAC 3A at resistive load
Solid-
state
Type
Single preset type : 1 NPN open collector
Dual preset type : 1st output 1 NPN open collector, 2nd output 1 NPN open collector
Capacity 30VDC Max. 100mA Max.
Memory protection 10 years(When using non-volatile semiconductor memory)
External sensor power 12VDC±10% 50mA Max.
Environ
-ment
Ambient temperature -10 to 55
℃
, storage: -25 to 65
℃
Ambient humidity 35 to 85%RH, storage: 35 to 85%RH
Insulation resistance Min. 100MΩ(at 500VDC megger)
Dielectric strength 2000VAC 50/60Hz for 1 minute
Noise
strength
AC power ±2kV the square wave noise(pulse width : 1
㎲
) by the noise simulator
DC power ±500V the square wave noise(pulse width : 1
㎲
) by the noise simulator
Item
Digit
Size
Output
FX 4 H 2P
IIndicator
No mark Single preset
2P Dual preset
LDIN W144×H72
mm
HDIN W48×H96
mm
No mark DIN W72×H72
mm
4 9999(4digit)
6 999999(6digit)
FX Counter/Timer
Please read “Caution for your safety” in operation
manual before using.
To Next Page
Need help?
General