8.
1
42
a) press the corresponding button on the remote control one more time;
b) Aim at the receiver of the controller, the remote control will send signal to the controller
per 3s, if the controller can t receive signal from remote control, this function will quit
automatically, TA will control temperature according to the TA sensor in the controller.
P.S.: When the I feel function start the main control board will stop detect the TA sensor.
When the indoor fan motor running, press the
negative ion button on the remote control,
the relay will open up and there is negative ion output, while the button was pressed, this
function will be quit
2) Quit the function
3. The negative ion function
,
To Next Page
Loading...
Need help?
General
