Axon Body 3 Camera User Manual
Axon Enterprise, Inc. Page 32 of 44
Camera Internal Clock
Axon Body 3 cameras should be regularly placed in an Axon Dock or connected to View XL
Standalone Mode to update the camera’s internal clock.
Wet Axon Body 3 Cameras
Do not charge your Axon Body 3 camera while the USB C connector on the camera or Dock
is wet.
If the USB C connector is wet, use a paper towel or absorbent cloth to blot the connector and
then allow the connector to fully dry.
If a camera is charging when it gets wet, remove the camera from the charging source (dock
or USB cable), use a paper towel or absorbent cloth to blot the connector, and then allow the
connector to fully dry.
The USB C connector must be fully dry before placing the camera in a dock or connecting a
USB C cable.
Camera Storage
Axon on-officer cameras should not be stored in environments where the temperature is
likely to exceed 95 °F (35 °C) (such as under direct sunlight, near heaters, or in a vehicle in
extremely hot weather) or exposed to temperatures below −4 °F (−20 °C). Axon recommends
the battery level is discharged to 40% or less before putting the camera in storage.
To Next Page
Loading...
Need help?
General
