Axon MICRELEC CS2600-BT User Manual

9
3 Progamming menus
3-1 Example 1: Single-parameter setting by scanning 1D barcodes
Important notes:
1. During the process of programming, LED is lighting to indicate the programming correctness. LED
will go off if any incorrect programming operation performed.
2. After each successful programming, LED will go off and the scanner will beep twice.
3. Throughout the programming barcode menus, the factory default settings are indicated with
asterisks (*).
Two programming modes have been provided as bellows:
❶ Single-scan setting
➢ Scan the appropriate Single-scan setting (e.g. %0101D00%) according to the user‘s demand.
Example: To set Flow control to be XON/XOFF.
Steps: Scan the following barcode.
❷ Multiple-scan setting
➢ Step 1. Scan the Option barcode barcode (e.g. %0101M%) according to the user‘s demand.
➢ Step 2. To the right of the option barcode, the necessary alphanumeric inputs are listed. Scan
two alphanumeric entries from 0 to 9 or A to F, refer to 10 Configuration alphanumeric entry
barcode.
➢ Step 3. Repeat Step 2, if more user parameters input are required.
➢ Step 4. Scan the %END% barcode, listed on the lower left hand corner of each parameter
setting part.
Example: To set Flow control to be XON/XOFF.
Steps: Referring to 3-8 RS-232 interface for cradle, scan the following barcodes in order.

Axon MICRELEC CS2600-BT Specifications

General

Brand	Axon
Model	MICRELEC CS2600-BT
Category	Barcode Reader
Language	English