the amplifier has cooled will be displayed on the
front panel of the preamplifier.
To restore the unit to the blue “Operate” mode, simply press
the front-panel button.
If the amplifier is linked to an
AyreLink-equipped preamplifier with an
alpha-numeric display, restoring operation of the
amplifier will clear any messages displayed on the
front panel of the preamplifier. (Messages may
also be cleared by placing the preamplifier in
“Standby”.)
Rail Fuses
Internal power supply fuses protect both the loudspeakers from
excessive current and the amplifier from short-circuits. If one of
these fuses blows, the amplifier will not operate and the status
LED will flash red.
If the amplifier is linked to an
AyreLink-equipped preamplifier with an
alpha-numeric display, a message indicating that
the amplifier has a blown fuse will be displayed
on the front panel of the preamplifier.
The amplifier must be disconnected from the system (including
AC power) to replace the fuse.
Do not remove the amplifier cover. Hazardous
voltages may exist inside the unit. Please refer
fuse replacement to a qualified service technician.
16
To Next Page
Loading...
Need help?
General
