03
NOTE: The factory only provides the heat pump unit. The other items in the illustration are necessary
spare parts for the water system which are provided by users or installers.
3. Installation
3.1 Installation illustration
(1) The heat pump unit must be installed by professional technicians .otherwise unit may
be damaged or body injured, even dead
(2) The unit is designed for outdoor location with good ventilation. Recirculation of cold
discharge air back into evaporator coil will greatly reduce heating capacity and
efficiency of the unit, which will void the compressor warranty.
(3) The unit can be installed almost anywhere in the outdoors.To get a good performance,
it needs to meet the three factors :
a) Good ventilation
b) Stable and reliable power supply
c) Recycled water system
The difference from gas water heater, it should not bring environmental pollution or
have the installing problems in-windy areas.
ATTENTION:
Please follow these steps when operating the first time :
1.Open valve and charge water
2.Make sure that the pump and the water-in pipe have been filled with water
3.Close the valve and start the unit
!
3.2 Installation
To Next Page
Loading...
Need help?
General
