44
WARNING:
The bulb could be HOT. Protect your fingers when
handle it.
The sewing light is located behind the face plate. To
change the bulb, take the face plate off the sewing
machine by removing the set screw.
• Unplug the power supply before changing the bulb.
• To remove, push up and turn the bulb to the left.
• To attach, push up and turn the bulb to the right.
Sewing Light
Oiling the Machine
Remove the cap, screw and face plate.
Apply a few drops of fine quality sewing machine oil to
the points indicated by the arrows in the
illustrations.
For a machine in constant use, oil two or three times a
year.
If the machine has stood idle for some time and does not
work smoothly, apply a few drops of
kerosene at the oiling points, and run the machine rap-
idly for one minute.
NOTE:
Before oiling, wipe off the oiling points.
Turn off the power switch when oiling the machine.
q Cap
w Screw
e Face plate
3
2
1
To Next Page
Loading...
Need help?
General
