1. Safety
• Special care for Laser B eam s: Spec ial care should be used when DLP projectors are used in the sam e room as h igh pow er
laser equipment. Direct or indirect hitting of a laser beam on to the lens can severely damage the D igital Mirror Devices
TM
in
which case there is a loss of warranty.
• Never place the projector in direct sunlight. Sunlight on the lens can severely dama ge the Digital Mirror Devices
TM
in which
case there is a loss of warranty.
• Save the original shipping carton and packing material. They will come in handy if you ever have to ship your equipment. For
maximum protection, repack your set as it w as originally packed at the factory.
• Disconnect the power to the projector before cleaning. Do not use liquid cleaners or aerosol c leaners. Use a damp cloth for
cleaning. Never use strong solvents, such as thinner or benzine, or, patrol, or abrasive c leaners, sin
ce these will damage the
cabinet. Stubborn stains m ay be r emov ed with a cloth lightly dampened with mild detergent solution.
• To ensure the highes t o ptical performance and resolution, the projection lenses are specially treated with an anti-reflective
coating, therefore, avoid touching the lens. To remove dust on the lens, use a so ft dry cloth. Do not use a damp cloth, detergent
solution, or thinner.
• Rated maximum amb ient temperature, t
a
= 35°C (95°F).
• The lamp house shall be r eplaced if it has bec ome d amaged o r thermally deformed.
• Do not stack DP2K-E series projectors.
On servicing
• Do not attempt t o service this product y ourself, as o pening or removing covers may expose you to dan gerous voltage p otentials
and r isk of electric shock.
• Refer all servicing to qualified s ervice personnel.
• Attempts to alter the factory-set internal controls or to change other contro
l settings not specially discussed in this manual c an
lead to per manent dam age to the projector and cancellation of the w arranty.
• Remove all po wer from the projector and refer s ervicing to qualified service technicians under the following conditions:
- When the power cord o r plug is damaged or frayed.
- If liquid has been spilled into the equipment.
- If the product has been expo sed to rain or water.
- If the product does not operate norm ally when the operating instructions are followed. Adjust only those controls that are
covered by the operating instructions since im proper adjus tment of the other controls may r esult in damage and will often
require extensive work by a qualified technician to restore the pr oduct to normal operation.
- If the product has been dropped or the cabinet ha s been dam aged.
- If the product exhibits a distinct change in performance, indicating a need for service.
• Replacement parts: When replacement pa rts are required, be sure the s ervice technician has used original Barco replacement
parts or authorized replacement parts which have the same cha racteristics as the Ba
rco o riginal part. Unauthorized substitu-
tions may result in degraded performance and reliability, fire, electric shock or other h azards. Unauthorized substitutions may
void wa rra nty.
• Safety check: Upon completion of any service or repairs to this projector, ask the service technic ian to perform safety checks
to determine that the product is in proper operating condition.
• Possible explosion hazard: A lways keep in mind the caution below:
To prevent battery explosion
• Danger of explosion if battery is incorrectly installed.
• Replace only with the same or equivalent type recomm ended by the manufacturer.
• For disposal of used batteries, always consult federal, state, local and provincial hazardous waste disposal r ules and regulations
to ensure proper disposal.
4
R5906695 DP2K-E SERIES 19/06/2015
To Next Page
Loading...
Need help?
General
