1. Safety
1.3 Product safety labels
Product safety labels
Label image Label d escription Label location
The Lamp H ouse is very hot after operation. To avoid
burns, let the projector cool down for at least 15 minutes
before proceeding to remove the Lam p House.
General Warning Haz ard
Electric Voltage Ha zard
Hot Surf ace Hazard
UV Hazard
Hazardous mov ing parts.
Keep away from moving fan blades.
Keep fingers and o ther body par ts away.
On the fans inside the projector
1.4 Lig ht beam Hazard Distance (HD
)
HD
Light beam Hazard Distance ( HD) is the distance from the source at which the intensity or the ene rgy per surface unit
becomes lower than the applicable safety limit. The light beam can thus be considered as dangerou s if the operator
is closer from the s ource than the HD.
Restriction Zone (RZ) based on the HD
The HD i s defined from the projection lens surface towards the position of the lowest projected beam where the irradiance eq uals
the applicable safety limit. The H D depends on the amo unt of lumens produced by the projector and the type of lens installed. See
next chapter HD in function of the lens Throw Ra tio (TR).
To protect untrained users the installation shall comply with the following ins tallation requirements: light output levels in excess of the
limits shall not be permitted at any point less than 2.0 meters (SH image 1-1) above any surface upon which persons are assum ed
to stand or 1 meter (S
W im age 1-1 ) below or in lateral separation from any place where such persons a re as sumed to be. S ee
image 1-1.
R5906695 DP2K-E SERIES 19/06/2015
5
To Next Page
Loading...
Need help?
General
