Baxi Power HT User Manual

103
912.199.3 - GB
ISTRUCTIONS PERTAINING TO THE INSTALLER
The boiler has been designed in full compliance with European reference standards and in particular is equipped
with the following:
• Overheatsafetythermostat
Thanks to a sensor placed on the heating ow, this thermostat interrupts the gas ow to the main burner in
case the water contained in the circuit has overheated. Under these conditions the boiler locks out and you
can only repeat the ignition procedure by pressing the reset button on the boiler after you have remedied
the cause of the trip.
It is strictly forbidden to disable this safety device.
• Fluethermostat
This device, positioned on the ue inside the boiler, interrupts the ow of gas to the burner if the temperature
exceeds 90 °C. After verifying the cause of the trip, press the reset button positioned on the thermostat
itself, then press the release button on the boiler.
It is forbidden to disenable this safety device
• Flameionizationdetector
The ame sensing electrode guarantees safety of operation in case of gas failure or incomplete interlighting
of the main burner.
Under such conditions the boiler is locked out.
You must press the reset button on the boiler to restore the normal operating conditions.
• Pumpoverrun
The electronic control system keeps the pump operating for 3 minutes in central heating mode after the
room temperature thermostat has switched off the main burner.
• Frostprotectiondevice
 Boilerselectronicmanagementincludesa“frostprotection”functioninthecentralheatingsystemwhich
operates the burner to reach a heating ow temperature of 30°C when the system heating ow temperature
drops below 5 °C.
This function is enabled as long as the boiler is connected to the a.c. power and gas supplies and the
pressure in the system is as specied.
• Pump-blockingprevention
In case there is no call for heat either from the central heating system or from the DHW system for 24 hours
on end the pump will automatically switch on for 10 seconds.
• Hydraulicpressuresensor
This device enables the main burner only to be switched on if the system pressure is over 0.5 bar.
15. CONTROL AND OPERATION DEVICES
If the electronic circuit board is replaced, make sure that the parameters set are those specic to the boiler
model, as indicated in the documentation available from the authorised Service Centre.

Baxi Power HT Specifications

General

Boiler Type	Condensing
Heat Exchanger Material	Stainless Steel
Fuel Type	Natural Gas
Type	Wall Hung
Weight	34 kg
Dimensions (H x W x D)	700 x 400 x 300 mm