Safety instructions
The following safety instructions and warnings are intended to avert hazards and to prevent property damage and personal injury.
It is important to follow these instructions.
General information
• In addition to the fire and accident prevention regulations, the safety instructions given in the current
standard version of EN12453, EN12978, VDE0100, EN50110, EN60204, EN50178, EN60335 and
ASRA1.7 must be observed.
• All work, including maintenance and cleaning, on electrical installations as well as other system parts
must always be performed by trained technicians, in particular qualified electricians.
• The limits given in the technical data must not be exceeded.
• The illustrations contained in these instructions are intended as an aid to understanding how the
product operates. Therefore, the illustrations may differ from the actual display on the product.
Caution
• When electrical or electronic equipment and units are operated, certain components are
live. Physical injuries or damage to property can result in the event of unauthorised inter-
ventions or failure to heed warnings.
• When moving the doors in dead-man mode it is necessary to ensure that the door region
is visible to the operator, since safety equipment such as the safety edge of the light bar-
rier is not effective in this operating mode.
• Operating the control unit when the housing is open is not allowed.
Attention
• Turning on or operating a control unit when dew is present on the unit is not allowed. It
can lead to the control unit being ruined.
Operating notes
• Do not allow children to play with permanently mounted regulating or control devices.
• Keep remote control units out of the reach of children.
• Systems have to be checked regularly by authorised specialists for wear and damage.
• It is forbidden to use a damaged controller.
• To avoid damage to the operator controls, they should not be touched with sharp objects. Only use
your fingers to use the operator controls.
• Do not operate equipment if people or objects are within the danger zone.
Caution
• If the connecting cable of this unit is damaged, it must be replaced by the manufacturer
or their customer service department or a similarly qualified person in order to avoid
hazards.
Notes on electrical connection and assembly
• All applicable standards and regulations for electrical installation must be complied with.
• Disconnect the electrical supply from the equipment before installing and connecting accessories and
extras, and protect against unauthorised reconnection in accordance with the safety regulations.
4
To Next Page
Loading...
Need help?
General
