Beckhoff AM8100 Series User Manual

Electrical installation
Synchronous servomotor 23Version: 2.1
Power box of the servomotor with iTec connector
Align the iTec connector (item 1) with the power box of the
servomotor (item 2). The iTec connector (item 1) should fully
enclose the silver-colored housing of the power box (item 2).
Note!:
Avoid contamination of or damage to the poles and the interior
of the box and the connector!
When connecting the two components, make sure that both
marking points (item 3) (white marking point on the iTec
connector, recessed grey marking point on the power box) face
each other.
Now push the iTec connector onto the power box of the
servomotor. This procedure causes the iTec connector to turn.
After the rotary motion the iTec connector engages on the
power box of the servomotor.
Note!:
When the connector engages on the power box, a “click” sound
can be heard. This indicates that the components were installed
correctly.
If the iTec connector cannot easily be pushed onto the power
box and made to engage, manually turn the white marking point
into the correct position (see Fig. 2 and 3).

Beckhoff AM8100 Series Specifications

General

Brand	Beckhoff
Model	AM8100 Series
Category	Engine
Language	English