Comissioning
Synchronous servomotor28 Version: 2.1
9 Comissioning
9.1 Important notes
DANGER
Serious risk of injury!
• Only specialist personnel with extensive knowledge in the areas of electrical engineering / drive technol-
ogy are allowed to install and commission the Equipment.
• Check that all live connection points are protected against accidental contact.
• Never undo the electrical connections to the motor when it is live.
• The surface temperature of the motor can exceed 100 °C in operation. Check (measure) the tempera-
ture of the motor. Wait until the motor has cooled down below 40 °C before touching it.
• • Make sure that, even if the drive starts to move unintentionally, no danger can result for personnel or
machinery.
9.2 Guide for commissioning
The procedure for commissioning is described as an example.
A different method may be appropriate or necessary, depending on the application of the Equipment.
• Check the assembly and orientation of the Motor.
• Check the drive components (coupling, gear unit, pulley) for the correct seating and setting (observe
the permissible radial and axial forces).
• Check the wiring and connections to the motor and the servo terminal. Check that the earthing is
correct.
• Test the function of the holding brake, if used. (apply 24 V
DC
, the brake must be released).
• Check whether the rotor of the motor revolves freely (release the brake, if necessary). Listen out for
grinding noises.
• Check that all the required measures against accidental contact with live and moving parts have been
carried out.
• Carry out any further tests which are specifically required for your System.
• Now commission the drive according to the commissioning instructions for the servo terminal.
• In multi-axis systems, individually commission each drive unit (servo terminal/motor(s)).
To Next Page
Loading...
Need help?
General
