Error handling and diagnostics
6.2 Faults
Please also refer to the Safety instructions section.
Possible faults and their correction
Fault Cause Measures
No function after the Embedded
PC has been switched on
No power supply for the Embedded
PC
other causes
1.Check the fuse
2. Measure voltage at connection,
check plug wiring, call Beckhoff
support
Embedded PC does not boot fully Hard disk damaged (e.g. due to
switching off while software is
running), incorrect setup, other
causes
Check setup setting, call Beckhoff
support
Computer boots, software starts,
but control does not operate
correctly
Cause of the fault is either in the
software or in parts of the plant
outside the Embedded PC
Call the manufacturer of the
machine or the software
Error during CFast card access CFast card faulty, CFast slot faulty Use a different CFast card to check
the CFast slot.Call Beckhoff
Support
Embedded PC only works partially
or temporarily
Defective components in the
Embedded PC
Call Beckhoff support
Please make a note of the following information before contacting Beckhoff service or support:
1. Precise device ID: CXxxxx-xxxx
2. Serial number
3. Hardware version
4. Any interfaces (N030, N031, B110, ...)
5. TwinCAT version used
6. Any components / software used
The quickest response will come from support / service in your country. Therefore please contact your
regional contact. For details please refer to our website at www.beckhoff.de or ask your distribution partner.
CX51x090 Version: 1.6
To Next Page
Loading...
Need help?
General
