LEARNING
1. Order overview
Valid only for references FX1600-S & FX1600
14
3. Use of the scooter
1. Turn the ignition key.
2. Place one foot on the platform, and turn the throttle grip slightly.
3. After building up some speed, put the second foot on the platform.
5. Press the accelerator to move forward.
6. Apply the brakes to slow down.
7. When the scooter is stationary, you can get off.
2. Details of functions
Settings
Short successive presses on:
• Battery voltage
• Mileage
• Total mileage (ODO)
• Wheel rotation speed (RPM)
• Driving time
To erase a data: long press on
Long press "C": activation of the speed regulator
The settings of your scooter MUST NOT be changed under any circumstances.
Error codes
Brake problem
Engine problem
Accelerator problem
Motherboard problem
FOLDING & UNFOLDING
Warning
• Folding and unfolding scooters can be difficult for the first few times.
• Before folding your scooter, make sure that it is switched off.
To fold your scooter, please refer to the diagram on p15:
Step 1: Remove the seat for the FX1000, FX1100 and FX1600 models.
Step 2: To do this, remove the safety pin located at the base of the saddle and pull it out.
Step 3: Then remove the safety pin at the folding handle, then pull the folding lever with one hand, pushing the mast
of your scooter with the other hand.
km/h
POWER
ASSIST
C
Speed
Top speed selection
Front light
ON / OFF button
Lower speed selection
Mileage
Battery level
Power of the motor Speed engaged
To Next Page
Loading...
Need help?
General
