Get hot water
ATTENTION
Risk of burns
The hot water pipe, nozzle and dispensed water are hot.
There is a risk of burns if touched!
► Do not touch the hot water pipe or the nozzle during
operation. Only operate the valve wheel to draw off water
(Francesca) or the valve lever (Francesca Leva).
► Avoid skin contact with the hot water. Also, watch out for
hot water splashes.
1. Hold a receptacle under the hot water nozzle and open the
valve:
– Inizio: by turning the valve wheel to the left
– Inizio Leva: by pushing the valve lever up or down
2. Close the valve when the required amount is reached:
– Inizio: by turning the valve wheel to the right
– Inizio Leva: by releasing the valve lever
The water taken from the boiler is immediately refilled from the
water tank. The withdrawal of a larger amount of water can
therefore lead to a drop in the boiler temperature. You may need
to top up with water.
Turn off the machine
1. Switch the machine off at the on / off switch if you do not
want to make any more coffee or if you no longer need steam
or hot water.
2. Remove the portafilter, knock it out and clean it under hot
water. However, do not use it until your next use so that the
rubber seal is not permanently under pressure and the sieve in
the brew group can dry out.
You can use the generated hot water e.g. use for the
preparation of tea or Caffé Americano (espresso with
additional hot water).
With the ECO mode, the machine switches itself off
automatically if it is not operated for a certain period of
time. In the delivery state, the ECO mode EC1 is set,
which means that the machine switches off after 35
minutes. When ECO mode is active, the display shows
EC1. For more information, see section “The ECO
mode” on page 18.
16 / 32
Bellezza | Espresso machines
Start up and operate the machine
To Next Page
Loading...
Need help?
General
