DANGER
Unsuitable cleaning agents
Unsuitable cleaning agents can scratch or damage the housing.
► Only use a soft, slightly damp cloth (e.g. microfiber cloth).
► You can use a cleaning agent specially designed for stainless
steel surfaces if it is heavily soiled.
► Never use scouring agents, agents with cleaning bodies,
sponges with scouring surfaces or wool.
Clean the housing
1. Switch off the machine and disconnect it from the power
supply.
2. If necessary, wait until all housing parts have cooled down.
3. Wipe the housing with a soft, slightly damp cloth (e.g.
microfiber cloth).
Measures before long periods of non-use
If it is foreseeable that the machine will not be used for a longer
period of time, Bellezza recommends the following measures:
1. Switch off the machine and disconnect it from the mains
voltage.
2. Remove the water tank, empty and clean it.
3. Empty the boiler completely. To do this, open the water drain
screw on the underside of the machine. Screw the screw back
in when the water has drained. After this measure, the
machine can also be stored below freezing point.
ATTENTION! Do not store the machine below freezing point
with a filled kettle. This can destroy the boiler.
4. Remove the portafilter from the brew group, clean it and
place it on the shelf.
Cleaning after long periods of non-use
Clean the water tank
► Empty the water tank, clean it and refill it completely.
Replace the boiler water
If the machine has not been used for a long time, the water in
the boiler should also be replaced.
1. Fill the water tank with fresh water and switch on the
machine.
2. Withdraw water through the hot water pipe.
3. Repeat the process until the water tank has been completely
emptied.
4. Fill the water tank again.
21 / 32
Espresso machines | Bellezza
Clean the machine
To Next Page
Loading...
Need help?
General
