Clean the shower screen and group seal
The shower filter and the group seal are located in the portafilter
holder of the brew group. The shower sieve presses on the
powder compacted in the portafilter and distributes the water
pressed in with pressure evenly over the powder surface. The
group seal seals the edge of the portafilter used against the brew
group. Constant contact with the coffee powder can
contaminate the sieve and seal and should therefore be cleaned
at regular intervals.
1. Remove the portafilter and place
a container under the brew
group.
2. Use the brush included in the
scope of delivery to remove
coffee residues and encrustations
from the sieve and the seal.
3. Use the reference lever to briefly
start the pump to rinse out the
brushed-off parts.
► Depending on the frequency of use, the shower strainer and
group seal should be replaced after a few years. Information
on this can be found in the section "Changing the shower
filter and group seal" on page 25.
Clean the housing
WARNING
Electric shock
Liquids that get into the machine can cause a short circuit and
electric shock. Serious injuries and damage to the machine and
can result.
► Only clean the machine when it is switched off. Also
disconnect the machine from the power supply.
► Make sure that no liquids get inside the machine.
► If liquids got inside the machine during cleaning, do not
connect the machine to the power supply and do not switch
it on. Depending on the amount of liquid that has entered,
wait until it has evaporated again. Contact your specialist
dealer if you are not sure.
ATTENTION
Risk of burns
Parts of the machine can still be hot even after switching off.
There is a risk of burns if touched!
► Only clean the machine when it is switched off.
► After switching off the machine, wait until all parts have
cooled down sufficiently.
20 / 32
Bellezza | Espresso machines
Clean the machine
To Next Page
Loading...
Need help?
General
