TRK 502/ 502X
43
f. The six sealing plugs on the cover strip align respectively to the six lling ports on the battery. Make sure the
ends of the six sealing plug has inserted into the lling ports on the battery; press them hard into the ports till the
cover strip makes a plane with the top surface of the upper part of the battery.
After completion of electrolyte lling, please do not pull out the cover strip or ll water, electrolyte or other liquid.
Pay attention to the following matters while replacing the battery.
Before replacing the battery, please rst determine the model of motorcycle and check if both batteries are of the
same type. During motorcycle design, the battery specications are considered as the best choice. If a battery of a
dierent model is used, it may aect performance and life time of the motorcycle, and possibly causes
electrical failure.
If the motorcycle will not be used for a long time, please remove the battery and charge it once a month.
THROTTLE CABLE ADJUSTMENT
1. Screw o the lock nut. 2. Turn the adjustor to make the cable clearance within10-20mm.
3. Retighten the lock nut after adjustment of cable clearance.
INSPECTION& MAINTENANCE
Warning：Battery will produce explosive gases when chemical reaction occurs in the battery.
Keep the battery away from re, spark and high temperature places.
The battery is lled with sulfuric acid (electrolyte). Electrolyte is poisonous substance.
Please keep it out of reach of children.
To Next Page
Loading...
Need help?
General
