TROUBLESHOOTING
10
MAINTENANCE AND CARE
CLEARING BLOCKAGES
FROM THE DIRT CONTAINER
1. Unplug the vacuum from the
electrical outlet.
2.Follow steps 1 to 3 on page 7 to
remove and open the dirt container.
3. Follow steps 2 to 3 on page 8 to
remove the dirt container filter.
4.Tap the dirt container filter
assembly over a garbage bin to
remove any dirt or debris from the
dirt container filter screen that
surrounds the dirt container.
5. Reach up into the dirt container to
clear any dirt or debris.
6. Check if there are any blockages in
the suction inlet.
7. After clearing any dirt or debris
from the dirt container, replace the
dirt container assembly into the dirt
container following step 7 on page 8.
Vacuum cleaner
won't run
Problem Possible causes Remedies
1. Power cord not firmly plugged in
1. Check electrical plug
2. Power button not pressed down 2. Press power button
Vacuum cleaner
doesn't vacuum
effectively
2. Filters are dirty 2. Follow instructions
for cleaning filters
on pages 8 and 9
1. Tools, hose or extension wands
are blocked
1. Remove each part
and check for
blockages
3. Follow instructions
for emptying the dirt
container on page 7
3. Dirt container is full
4. Check that hose
connector is locked
into suction inlet
4. Hose connector not securely
attached to suction inlet
5. Check hose and
replace if necessary
5. Crack or hole in hose
6. Change to closed or
maximum setting
6. Air flow regulator is set to open
or minimum setting
7. Clear blockage from
the dirt container
following steps 1 to
7 at the top of this
page.
7. Blocked dirt container
To reduce the risk of electric shock, turn Power
Switch OFF and disconnect plug from electrical
outlet before performing troubleshooting checks.
!
WARNING:
To Next Page
Loading...
Need help?
General
