STORING
• The pump, hose and accessories should always be emptied of water prior to storing
as follows:
1. Switch OFF the machine and detach the water hose and accessories
2. Restart the machine and pull the Spray Gun Trigger. Let the machine run until no
more water runs through the spray gun
3. Stop the machine, unplug and wind up the hose and power cord
• Place the Spray Gun, Spray Lances and other accessories on the onboard storage
holders on the machine
• The machine should never be stored in any area where there is frost or where the
machine may freeze. Should the machine be frozen by mistake, it will be necessary
to check it for damage. NEVER START-UP A FROZEN MACHINE. Frost damages are
not covered under guarantee. Contact the Service Centre in such cases
• Store the machine out of reach of children
MAINTENANCE
TO ENSURE A LONG AND PROBLEM-FREE WORKING LIFE FOR YOUR PRESSURE
WASHER, PLEASE ADHERE TO THE FOLLOWING:
• Wash out water hose, high pressure hose, spray lance and accessories before storing
• Clean the connectors of dust and sand
• Rinse the Detergent Bottle after use
• Clean the Spray Lances and Spray Gun
Any necessary repairs should only be made by an authorized Tevo Service Centre with
original spare parts. See page 13 for Tevo Service Centre contact details.
CLEANING THE WATER INLET FILTER (6A):
• Clean the Water Inlet Filter at least once a month or more frequently according to use
• Carefully loosen the filter with a screwdriver and clean it. Check that it is intact
before re-mounting it
• The Water Inlet Filter must always be fitted inside the Water Inlet Pipe (6) to filter out
sand, limestone and other impurities which will damage the pump valves
Always disconnect the electrical plug from the socket prior to maintenance or
cleaning.
!
WARNING:
Failure to fit the filter will invalidate the GUARANTEE.
!
CAUTION:
10
To Next Page
Loading...
Need help?
General