Bennett Read IND2000 User Manual

MAINTENANCE
To prevent clogging which will put the pump under strain, clean the Spray Lance nozzle
often using the following steps:
1. Switch OFF the machine and disconnect the Spray Lance
2. Use the Cleaning Tool to clean the Spray Lance Nozzle (Fig. 13)
3. Flush the nozzle backwards with water
The machine air vents should be kept clean and free from blockages to let air pass
through freely.
The couplings should be greased regularly to ensure an easy connection and that the
O-rings do not dry up.
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSES SOLUTION
Machine won’t
start
1. Machine not plugged in
2. Defective socket
3. Defective extension cord
1. Plug in machine
2. Try another socket
3. Try without the
extension cord.
Fluctuating
pressure
1. Pump sucking air
2. Valves dirty, worn out or stuck
3. Pump seals worn out
1. Check that hoses and
connections are
airtight
2. Clean and replace or
refer to Service Centre
3. Clean and replace or
refer to Service Centre
11
Fig. 13
Needle clean-out tool

Bennett Read IND2000 Specifications

General

Brand	Bennett Read
Model	IND2000
Category	Pressure Washer
Language	English