7
OPERATION
Adjust the water jet to pencil or fan by turning the end of the Spray Lance clockwise or
anticlockwise.
Adjust the pressure by turning the lower ring in the direction of the “+” or “-”
(Fig. 9).
NOTE: The Turbo Lance is not adjustable.
DO NOT use the Turbo Lance on wood, painted or other delicate surfaces as it may cause
damage.
Fig. 9
Pencil spray
Pressure adjustment ring
Nozzle tip
• Check that the machine is securely upright on level ground
• Make sure the ON/OFF Switch (2) is in the OFF position, then insert the electrical
plug into the mains socket
• Be aware that the Spray Gun will kick when the trigger is pulled. Make sure to hold
the Spray Gun and Spray Lance firmly with both hands during use
• IMPORTANT: Aim the Spray Lance at the ground to adjust before starting to clean
• Release the Trigger Lock (10A)
• Pull the trigger of the spray gun and let the water run until all air has escaped from
the water hose
• Turn the ON/OFF Switch (2) to the ON position
• Pull the trigger of the spray gun to begin spraying
• Aim the Spray Lance AWAY from the surface to be cleaned to adjust the Spray Lance
pressure to the desired settings before aiming at the intended surface
• Adjust the distance and thus the pressure of the Spray Lance to the surface which is
being cleaned
• When releasing the Spray Gun trigger the machine will stop automatically. The
machine will start again when you reactivate the Spray Gun
Fan spray
Foam spray
To Next Page
Loading...
Need help?
General