10
To reduce the risk of electric shock, turn the
Power Switch OFF and disconnect the plug
from the electrical outlet before performing
troubleshooting checks.
!
WARNING:
TROUBLESHOOTING
Vacuum cleaner
won't run
PROBLEM POSSIBLE CAUSES REMEDIES
1. Power cord not firmly plugged in
1. Check electrical plug
2. Power button not pressed down 2. Press power button
Vacuum cleaner
doesn't vacuum
effectively
2. Filters are dirty 2. Follow instructions
for cleaning filters
on pages 7 - 9
1. Tools, hose or extension wands
are blocked
1. Remove each part
and check for
blockages
3. Follow instructions
for emptying the dirt
container on page 6
3. Dirt container is full
4. Check that hose
connector is locked
into suction inlet
4. Hose connector not securely
attached to suction inlet
5. Check hose and
replace if necessary
5. Crack or hole in hose
6. Change to closed
6. Air-flow regulator is set to open
7. Clear blockage from
the dirt container
following steps 1 to
7 at the top of this
page.
7. Blocked dirt container
Dust blows out
of the air vents
1. Dirt container is full 1. Empty the dirt
container
2. Filters missing or installed
incorrectly
2. Check all filters for
correct installation
3. Filters are dirty 3. Check and clean or
replace all filters
4. Hose connector is blocked 4. Remove hose and
check for blockages
5. Hose connector is not securely
attached to the suction inlet
5. Make sure the hose
connector is locked
into the suction inlet
6. Crack or hole in hose 6. Check hose and
replace if necessary
Other maintenance or service not included
in the manual must be performed by an
authorized Tevo service representative. For
any questions or concerns, contact customer
care on 0861 77 88 88.
To Next Page
Loading...
Need help?
General
