Bennett Read MULTI-FORCE User Manual

4
ASSEMBLY
1. Connect the hose (7) to the vacuum by
inserting the hose connector (10) into
the suction inlet (11) until it clicks into
place
2. Connect the 2-Piece extension wand by
pushing the small end of one piece into
the large end of the other piece. Then
twist slightly to fasten
3. Connect the hose handle (6) to the end
of the extension wand and twist slightly
to tighten
4. Connect the floor nozzle (1) to the other
end of the extension wand and twist
slightly to tighten
5. Once assembled, you can store your
vacuum by inserting the storage clip
(located on the back of the floor nozzle)
into the storage slot (20) on the rear of
the vacuum
OPERATIONS
POWER CORD
The power cord (19) is located at the rear
of the vacuum. Gently pull the power cord
out. Stop pulling the cord when the yellow
line is visible. There is also a red line which
indicates the end of the usable cord. Do
not pull the power cord out beyond the red
line.
AUTO-CORD REWIND
Your vacuum is equipped with an
automatic cord rewind. When cleaning is
finished, press the power button to switch
the vacuum OFF and grasp the plug to
disconnect from the electrical outlet. Hold
the plug and press the auto cord rewind
button to rewind the cord automatically.
POWER BUTTON
Turn the power ON or OFF by pressing
lightly downward on the power button.
1.
2.
3.
4.
The power cord retracts very quickly.
Take care to avoid injury.
!
CAUTION:
AUTO
CORD
REWIND
POWER
BUTTON

Bennett Read MULTI-FORCE Specifications

General

Brand	Bennett Read
Model	MULTI-FORCE
Category	Vacuum Cleaner
Language	English