Bennett Read MULTI-FORCE User Manual

To avoid injury, turn the vacuum OFF and
unplug the cord from the wall when not in use.
!
WARNING:
Hair, string and small objects can block the
hose and tools. Check them occasionally for
obstructions.
TIP:
MAINTENANCE AND CARE
To reduce the risk of injury from moving parts
and/or electrical shock, turn the Power Switch
OFF and disconnect the plug from the electrical
outlet before performing maintenance checks.
!
WARNING:
EMPTYING THE DIRT CONTAINER
Empty the dirt container as soon as the dirt
reaches the “FULL” line on the sides of the
dirt container.
1. Unplug the vacuum from the electrical
outlet
2. Remove hose by pressing the release
button and pulling the hose connector
out from the suction inlet. Set hose aside
3. Press the dirt container release button (9)
and lift up to remove the dirt container
4. Choose an emptying method (method
#2 is recommended for allergy sufferers).
Method #1 - Hold the dirt container
over a rubbish bin and push the
emptying button to open the bottom.
Close the bottom after the dirt empties.
Method #2 - Place a plastic bag over
the bottom of the dirt container. Push
the emptying button through the plastic
bag to open the bottom. After the dust
settles, close the bottom and remove the
plastic bag to discard
5. Replace the dirt container by sliding it
back into the vacuum from the top. Then
push down gently on the dirt container
until it clicks back into place.
Make sure that the locking clasp is
properly fastened.
TO MAINTAIN MAXIMUM
PERFORMANCE FROM YOUR
MULTI-FORCE VACUUM,
PERFORM THESE SIMPLE
MAINTENANCE CHECKS:
2.
3.
4.
5.
6

Bennett Read MULTI-FORCE Specifications

General

Brand	Bennett Read
Model	MULTI-FORCE
Category	Vacuum Cleaner
Language	English