22
TROUBLE SHOOTING
Should you experience any challenges with your BENNETT READ ONE,
please check the following before sending it to a repair centre:
Other maintenance or service not included in the manual must be performed by an authorized
Tevo service technician. For any questions or concerns, contact customer care on 0861 77 88 88
To reduce the risk of electric shock, turn the power switch OFF and disconnect the plug from the electrical outlet before performing
any trouble shooting checks.
WARNING:
PROBLEM POSSIBLE CAUSES REMEDIES
Reduced spray or no spray 1. Solution tank may be empty
2. Cleaning solution spray pipe may be disconnected
1. Check if pump switch is turned on
2. Check that pipe is connected
Reduced or no suction 1. Filters may be dirty.
2. Dust bag may be full
3. Blockage in flexi hose or attachment.
4. Air flow cut-off valve has tripped.
(Wet vacuuming and deep cleaning)
5. Hose connector not securely attached to suction inlet
1. Check and clean all filters as described
earlier in this guide
2. Check and empty dust bag as described
earlier in this guide
3. Remove and check as described earlier in this guide
4. Check and empty dirt collection tank (6)
5. Check that both flexi hose securing clips (30)
are clipped in properly
Visible dust escaping from your BENNETT READ ONE 1. Filters dirty or missing
2. Dust bag full
3. Crack or hole in the flex hose
1. Check that all filters are clean and properly installed
2. Check and empty dusty bag
3. Check and replace if necessary
To Next Page
Loading...
Need help?
General
