SKR Pro V1.2 User Manual Shenzhen Biqu Technology Co., Ltd.
18 / 18
XI 、Notes
1、Currently, only our company's open source firmware
Marlin2.0 is supported.
2、U-disk functionality is not supported for the time being.
so stay tuned!
3、 The power of the hot bed connected to the motherboard
must be less than or equal to 180W ( the thermal bed
resistance value is greater than 0.8)
4、when the motherboard is supplied with 12V/24V power
supply, be sure to pay attention to the positive and negative
poles of the power supply.
5、The firmware file name in the SD card cannot be changed,
including capitalization.
6. Ensure that all wires, jumper caps and drivers are correctly
plugged in before power-on.
7. Do not plug or unplug the drive module with power to
avoid damage.
8. When wiring the motherboard, be sure to pay attention to
the positive and negative power supply, drive direction, power
supply selection, etc., in order to power on.
To Previous Page
Loading...
Need help?
General
