11
After deep cleaning/wet vacuuming
1. Rinse filling cavity with clean water. Leave about 1/2
gallon of clean water in filling cavity.
2. Hold floor nozzle over bucket or sink.
3. Turn on pump/spray switch, pull trigger for 30 seconds,
and empty power unit.
4. Empty filling cavity of excess water.
5. Drain solution hoses.
6. Empty and rinse collection tank.
7. Rinse and dry collection tank, ball cage, ball, wands,
and tools.
8. Remove tank siphon tube from opening on power unit.
9. Remove filter from end of tank siphon tube, clean filter
under running water, then replace filter in end of tank
siphon tube.
10. Replace tank siphon tube in opening in power unit.
11. We recommend that you air dry before closing unit
for storage.
After dry vacuuming
1. Remove motor filter from top power unit and rinse with
water. Squeeze to remove water, then air dry before
reinstalling. Clean after each vacuuming.
2. Remove dry filter bag from ball cage. Shake to remove
surface dirt. Rinse bag by hand in warm water.
Air dry before reinstalling.
Tip:
Always clean
floor nozzle
spray tip and
tank siphon
tube filter
before storing
appliance.
Tank siphon
tube filter
To Next Page
Loading...
Need help?
General
