1. Disconnect wand solution tube and aluminum wands from
grip/trigger unit.
2. Moisten O-ring at base of cap valve with soapy water.
3. Align small area cleaning nozzle with cap valve and
vacuum tube on grip/trigger unit.
4. Press latch button on vacuum tube and slide small area
cleaning nozzle on until latch button locks in place.
5. Check manufacturer’s tag and/or test fabric in an
inconspicuous place.
How to clean upholstery and small areas
Getting ready
8
1. Turn on vacuum/suction and pump/spray switches.
2. Depress trigger and pull small area cleaning nozzle
toward you.
3. Release trigger and repeat action to extract excess moisture.
4. Repeat until area is clean.
5. See WHEN YOU’RE DONE, page 7 and PUTTING IT AWAY,
page 11.
Cleaning
To clean upholstery, disconnect
wand solution tube and aluminum
wand from grip/trigger unit.
Moisten O-ring at base of cap
valve with soapy water. Align the
Small Area Cleaning Nozzle
with the cap valve and vacuum
tube on grip/trigger unit, then
press latch button on vacuum
tube and slide together until latch
button locks in place.
Tip:
Check upholstery
stuffing before
cleaning.
Colored stuffing
may bleed
through fabric
when wet.
Vacuum/suction switch
Pump/spray switch
To Next Page
Loading...
Need help?
General
