This user’s guide has been designed to help you
get the utmost satisfaction from your BISSELL
PowerWash Pro. You’ll find assembly and operating
instructions, safety precautions, as well as
maintenance and troubleshooting instructions.
Please read this user's guide thoroughly before
assembling your deep cleaner.
Pay particular attention to the product diagram,
assembly instructions, and part names. Locate
and organize all parts before assembly. Familiarize
yourself with the parts and where they go.
Following this user’s guide will greatly enhance
your ability to get the most performance from your
BISSELL PowerWash Pro for many years.
Your
PowerWash Pro comes in three, easy to
assemble components:
Upper Handle
Lower Handle
Tool Caddy
The only thing you will need to assemble your
cleaner is a Phillips head screwdriver.
Refer to Assembly Diagram on page 5
1.
Slide upper handle onto lower handle.
2. Feed bundled power cord through tool caddy from
caddy’s flat side.
3. Align upper handle holes and tool caddy holes.
4. Place hex nut into back of tool caddy and hold in
place. Insert bolt from front to back, turning into
the hex nut until snug. Do not over tighten. Repeat
for the second bolt and hex nut.
5. Insert 2 screws into lower 2 holes. Turn until snug.
6. Snap tools into storage on the tool caddy.
7. Wrap power cord and flex hose as shown in figure 7.
PowerWash Pro assembly is now complete.
How to use this guide
6
www.bissell.com
WARNING:
Do not plug in your cleaner
until you have completely
assembled it per the
following instructions
and are familiar with all
instructions and operating
procedures.
7
1 2
3 4
5 6
Assembly
Special features
Your BISSELL PowerWash Pro deep cleaner is a
home cleaning system that uses a combination
of hand hot tap water, BISSELL deep cleaning
formulas and suction to safely clean carpets and
upholstery.
To Next Page
Loading...
Need help?
General
