Blaupunkt Sydney 220 BT User Manual

11
Inserting/ejecting a CD
(Helsinki 220 BT and London 120)
Inserting a CD
Risk of severe damage to the CD
drive!
Noncircular contoured CDs (shape CDs)
and CDs with a diameter of 8 cm (mini CDs) must
not be used.
We accept no responsibility for any damage to the
CD drive that may occur as a result of the use of
unsuitable CDs.
Note:
You must not hinder or assist the drive as it
automatically draws in the CD.
쏅 Insert the CD with its printed side up into the
CD tray
5 until you feel a slight resistance.
The drive automatically draws in the CD and
checks its data. Afterwards, the playback
starts in CD or MP3 mode.
Note:
If the inserted CD cannot be played back, "CD
ERROR" is brie y displayed and the CD is au-
tomatically ejected after approx. 2 seconds.
Ejecting a CD
Note:
You must not hinder or assist the drive as it
ejects the CD.
쏅 Press the
button 8 to eject an inserted
CD.
Notes:
• If a CD is ejected and not removed, the
drive will automatically draw it back in
again after approx. 10 seconds.
• You can also eject CDs while the car sound
system is switched o or whilst another au-
dio source is activated.
Connecting/removing a USB data
carrier
Connecting a USB data carrier
쏅 Switch o the car sound system so that the
data carrier will be correctly registered.
쏅 Pull the protective cap of the USB socket
:
to the front until it moves out of the socket
and fold it down.
쏅 Connect the USB data carrier.
쏅 Turn on the car sound system.
If the USB data carrier is initially selected as
audio source, the data are read  rst.
Notes:
• If the connected USB data carrier cannot
be seen, "USB ERROR" is brie y displayed.
• The time required for reading in the data
depends on the design and size of the USB
data carrier.
Removing a USB data carrier
쏅 Switch o the car sound system so that the
data carrier will be correctly unregistered.
쏅 Disconnect the USB data carrier.
쏅 Close the protective cap of the USB socket
: .
Inserting/removing a memory card
(Sydney 220 BT and Melbourne 120)
Inserting a memory card
쏅 Switch o the car sound system so that the
memory card will be correctly registered.
쏅 Open the cover of the card slot B .
쏅 Insert the memory card with its labelled side
up and its contacts  rst into the card slot
B
until it clicks into place.
쏅 Close the cover of the slot again.
쏅 Turn on the car sound system.
After switch-on, the device automatically
selects the inserted memory card as audio
source. The data of the memory card are read.
Afterwards, the playback starts in MP3 mode.
CD/MP3/WMA mode

Blaupunkt Sydney 220 BT Specifications

General

Brand	Blaupunkt
Model	Sydney 220 BT
Category	Car Receiver
Language	English