EasyManuals Logo
Home>BMC>Medical Equipment>G2S B20A

BMC G2S B20A User Manual

BMC G2S B20A
47 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #23 background imageLoading...
Page #23 background image
G2S BPAP Series User Manual V2.1
20 / 43
CAUTIONS!
Do not position the device where it is difficult to operate the disconnection device.
To isolate the device from the supply mains, disconnect the plug.
13. Heated Humidifier
The humidifier is available from your home care provider. The humidifier may reduce nasal
dryness and irritation by adding moisture (and heat if applicable) to the airflow.
13.1 Filling the Water Chamber
13.1.1 Removing the Water Chamber
Grab the water chamber, and pull it out of the device, as shown in the figure below.
Fig. 13-1
WARNING!
Turn the device off and allow approximately 15 minutes for the heater plate and water to
cool.
13.1.2 Filling Water
Open the cap, as shown in Fig. 13-2, and fill the water chamber with approximately 360 ml
of water, as shown in Fig. 13-3. Make sure that the water does not exceed the maximum
water level line.
Fig. 13-2

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the BMC G2S B20A and is the answer not in the manual?

BMC G2S B20A Specifications

General IconGeneral
BrandBMC
ModelG2S B20A
CategoryMedical Equipment
LanguageEnglish

Related product manuals