G2S BPAP Series User Manual V2.1
22 / 43
13.2 Emptying the Water Chamber
(1) Removing the water chamber according to instructions in 13.1.1.
(2) Emptying the water chamber: Open the cap, as shown below, and pour any
remaining water out of the water chamber.
Fig. 13-6
CAUTION!
• Empty and air-dry the water chamber when the device is not in use.
(3) Inserting the Water Chamber according to instructions in 13.1.3.
13.3 Setting the Humidity Level
After the device is powered on, turn the Knob to turn on or turn off the heated
humidifier and to adjust the humidity level according to instructions on the screen of the
device.
There are five humidity levels available, and the number of blue indicator lights that light up
is directly proportional to the humidity level. If none of the indicator lights light up, it means
that the heated humidifier is turned off.
The temperature of the water in the water chamber maintains a constant set level. Three
indicator lights light up when the humidity is adjusted to Level 3, as shown in Fig. 13-7.
Fig. 13-7
CAUTIONS!
• Generally speaking, the humidity inside the mask is low when the water temperature is low.
• The greater the difference between the temperature inside the air tubing and room
temperature is, the more easily condensation occurs inside the tubing.
• If there are only a few condensed water droplets inside the tubing in the morning after
therapy, it means that the humidity level is appropriate; if there is lots of condensed water
droplets inside the tubing and / or mask, it means that the humidity level is too high and should
be set lower; Nasal dryness means that the humidity level is too low and should be set higher.
To Next Page
Loading...
Need help?
General
