with BMW Motorrad ABS
OE
Insert ABS sensor into hole
and install screw 1.
Remove adhesive tape from
wheel rim.
Operate brakes several times
until brake pads contact brake
disk.
Firmly compress spring forks
several times.
Tighten right axle clamping
screws 1 to specified tight-
ening torque.
Pinch bolt of quick-re-
lease axle
Tightening sequence: 2x
each side, alternately
14 lb/ft (19 Nm)
Removing rear wheel
Make sure ground is level and
firm and park motorcycle.
Remove screw 1 and take
speed sensor out of hole.
Make sure ground is level and
firm and place motorcycle on a
suitable auxiliary stand.
with center stand
OE
Make sure ground is level and
firm and place motorcycle on
center stand.
8
99
z
Maintenance
To Next Page
Loading...
Need help?
General
