Damping
Setting
The damping must be adjusted
to the road conditions and the
spring preload.
A rough road surface requires
softer damping than a smooth
road surface.
An increase in spring preload
requires firmer damping, a re-
duction in spring preload re-
quires softer damping.
Adjust damping on rear
wheel
Make sure ground is level and
firm and park motorcycle.
If you want a harder damping
characteristic, use the tool from
the onboard toolkit to turn ad-
justing screw 1 in the direction
indicated by the H arrow.
If you want a softer damping
characteristic, use the tool from
the onboard toolkit to turn ad-
justing screw 1 in the direction
indicated by the S arrow.
Basic setting of rear
wheel rear-wheel damp-
ing
without Electronic Suspen-
sion Adjustment (ESA)
OE
Basic setting of rear
wheel rear-wheel damp-
ing
Turn the adjusting screw as
far as it will go in the direc-
tion indicated by the H arrow
and then turn it back one
and a half turns in the direc-
tion indicated by the S arrow
(Full tank of gas, with rider
187 lbs (85 kg))
ESA Electronic
Suspension Adjustment
with Electronic Suspension Ad-
justment (ESA)
OE
Settings
You can use the ESA Electronic
Suspension Adjustment feature
to adapt your motorcycle to its
current load as well as the road
surface. This entails selecting
4
65
z
Operation
To Next Page
Loading...
Need help?
General
