3
71
Starting – Riding – Parking
BMW Integral ABS - Fault table
General war-
ning light e
ABS warning
light l/
brake failure
Malfunctions
OFF ON Only RESIDUAL BRAKING FUNCTION
available in both circuits (
b 67)
OFF Flashes at 1 Hz ABS not available
Pull-away test not completed (
b 68)
OFF Flashes at 4 Hz Only RESIDUAL BRAKING FUNCTION
available in both circuits (
b 67)
Self-diagnosis not completed (
b 68)
ON OFF Tail light/brake light inoperative
(
b Maintenance Instructions, Chapter 2)
ON Flashes at 1 Hz At least one brake circuit without
ABS (
b 66)
ON Flashes at 4 Hz At least one brake circuit in RESIDUAL
BRAKING FUNCTION mode (
b 67)
Alternate
flashing at
1 Hz
Alternate flash-
ing at 1 Hz
Fluid level in BMW Integral ABS too low.
Check the motorcycle as follows:
– Ignition OFF: is brake pressure OK at
the brake levers?
– Are the brakes acting on both wheels?
– Is the brake system free from leaks, no
signs of brake fluid escaping?
If the test outcome is negative it will be
necessary to diagnose the brake system
and address any faults as necessary.
Alternate flas-
hing at 4 Hz
Alternate flas-
hing at 4 Hz
Fluid level in the BMW Integral ABS is too
low, perform the checks listed above.
Only RESIDUAL BRAKING FUNCTION
available in at least one circuit (
b 67)
Do not ride the motorcycle if you
have any doubts about the
dependability of the brake system.
10r22bku3.book Seite 71 Freitag, 27. Januar 2006 1:22 13
To Next Page
Loading...
Need help?
General
