The display starts with the cur-
rent value and each time the but-
ton is pressed it moves one step
through the following sequence:
Total distance covered
Tripmeter 1 (
Trip I)
Tripmeter 2 (
Trip II)
Tyre pressures (OE)
Warnings, if applicable
Resetting tripmeter
Switch on the ignition.
Select the desired tripmeter.
Press and hold down button 2.
The tripmeter is reset to zero.
Residual range
without on-board computer
OE
The residual-range readout in-
dicates how far you can ride with
the fuel remaining in the tank.
This reading is not displayed until
fuel level has dropped to reserve.
This distance is calculated on the
basis of fuel level and average
consumption.
When refuelling after running on
reserve, make sure that you top
up the tank to a level above re-
serve, as otherwise the sensor
will not be able to register the
new level. If the sensor cannot
register the new level neither
4
45
z
Operation
To Next Page
Loading...
Need help?
General
