Tampering with the engine
control unit can result in
mechanical loads that the mo-
torcycle's components are not
designed to withstand. Damage
caused in this way is not covered
by the warranty.
Do not tamper with the engine
control unit.
Checklist
Use the following checklist to
check important functions, set-
tings and wear limits before you
ride off.
Brakes
Brake-fluid levels, front and rear
Clutch
Clutch fluid level
Damping-characteristic setting
and spring preload
Tyre-tread depth and tyre
pressures
Cases correctly installed and
luggage secured
At regular intervals:
Engine oil level (every refuelling
stop)
Brake-pad wear (every third
refuelling stop)
Starting
Side stand
You cannot start the motorcycle
with the side stand extended and
a gear engaged. The engine will
switch itself off if you start it with
the gearbox in neutral and then
engage a gear before retracting
the side stand.
Gearbox
You can start the engine when
the gearbox is in neutral or if you
pull the clutch with a gear en-
gaged. Do not pull the clutch un-
til after you have switched on the
ignition, as otherwise the engine
will refuse to start.
Starting engine
Kill switch in run position a.
Switch on the ignition.
Pre-ride check is performed.
( 67)
with BMW Motorrad Integral
ABS
OE
ABS self-diagnosis is
performed. ( 68)
with Automatic Stability Control
(ASC)
OE
ASC self-diagnosis is per-
formed. ( 68)
5
66
z
Riding
To Next Page
Loading...
Need help?
General
