Activating ASC function
Press and hold down ASC but-
ton 1 until the ASC warning
light changes status.
ASC warning light goes out;
if self-diagnosis has not
completed the ASC warning light
starts flashing.
Release the ASC button within
two seconds.
The ASC warning light re-
mains off or continues to
flash.
The ASC function is activated.
Instead of pressing the ASC
button, you have the option of
switching the ignition off and
then on again.
An ASC fault has occurred
if the ASC warning light
shows when the motorcycle ac-
celerates to a speed in excess
of 10 km/h after the ignition was
switched off and then on again.
Grip heating
OE
1 Grip-heating switch
The handlebar grips have two-
stage heating. Grip heating can
be activated only when the en-
gine is running.
The increase in power con-
sumption caused by the
grip heating can drain the bat-
tery if you are riding at low en-
gine speeds. If the charge level
is low, grip heating is switched
off to ensure the battery's start-
ing capability.
2 Heating off.
3 50 % heat output (one dot
visible)
4 100 % heat output (three
dots visible)
4
53
z
Operation
To Next Page
Loading...
Need help?
General
