One-up with luggage
Two-up (with luggage)
The setting shows briefly, then
disappears automatically.
Adjusting suspension
Start the engine.
Press button 1 once to view
the current setting.
To set the damping, repeatedly
short-press button 1 until the
setting you want to use ap-
pears on the display.
You can adjust the damping
characteristic while the mo-
torcycle is on the move.
To set the load mode,
repeatedly long-press button 1
until the setting you want to
use appears on the display.
The load cannot be set
while the motorcycle is in
motion.
The damping and load settings
shown on the display are ac-
cepted if you allow a certain
length of time to pass without
pressing button 1; the ESA
setting then automatically dis-
appears from the display.
Tyres
Checking tyre pressure
Incorrect tyre pressures im-
pair the motorcycle's hand-
ling characteristics and increase
the rate of tyre wear.
Always check that the tyre pres-
sures are correct.
At high road speeds, tyre
valves installed perpen-
dicular to the wheel rim have a
tendency to open as a result of
centrifugal force.
In order to avoid a sudden loss of
tyre pressure, fit a valve cap with
rubber sealing ring to the rear
tyre and make sure that the cap
is screwed on firmly.
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Check tyre pressures against
the data below.
Tyre pressure, front
2.2 bar (one-up, tyre cold)
2.5 bar (two-up and/or with
luggage, tyre cold)
4
58
z
Operation
ProCarManuals.com
To Next Page
Loading...
Need help?
General
