92n
Computer in the MID*
After three incorrect code inputs, or
three attempts to start the engine with-
out a code input, the alarm will sound
for 30 seconds on vehicles fitted with
an alarm.
Deactivating the alarm in an
emergency:
If you have forgotten the code, proceed
as follows:
1 Disconnect the battery, wait approx.
2 minutes, then reconnect it. Note
that on vehicles with an alarm, this
will sound.
2 Set the ignition key to position 1:
The time display will count down for
the next ten minutes.
3 After ten minutes, start the engine.
If the code becomes available
again in the meantime, it can be
input during the waiting period after
pressing the CODE button.<
Remote control
The button on the turn indicator lever
can be used to select the items of
computer information which are to
be displayed.
To do this, press
> the button on the lever until PROG 1
shows on the display.
> the MID buttons in the order in which
you wish the information to be dis-
played.
Each time an entry is stored, the pro-
gram number appears on the display.
To terminate the selection procedure:
Press the right side of the button.
530us047
To have all the available information
displayed, press
> the button on the lever until the
display shows PROG 1.
> the SET button.
To obtain individual items of informa-
tion, press the button in briefly as often
as necessary.
To Next Page
Loading...
Need help?
General
