96n
2-axle self-leveling suspension* Brake force display
Lowering
Available with ignition key in position 2.
From Standard to Access:
1. Press button 2 while traveling at less
than approx. 50 mph/80 km/h. The
system enters its preselection mode.
The preselection mode is canceled
> by pressing button 1
> automatically once the vehicle
exceeds a speed of approx.
50 mph/80 km/h or roughly
60 seconds after button 2 is
pressed
2. Reduce speed to below approx.
15 mph/25 km/h within roughly
60 seconds after pressing button 2.
When you press button 2 at
speeds below approx. 15 mph/
25 km/h the system automatically low-
ers the vehicle to the Access level.<
From Off-Road to Standard:
> Press button 2 or
> automatically once you exceed a
speed of approx. 30 mph/50 km/h.
The Brake force display indicates the
intensity with which you are applying
your brakes to drivers of following vehi-
cles.
The display consists of two stages:
> Normal braking:
The brake lamp units within the tail
lamps and the high-mount brake
lamp integrated within the rear
spoiler both light up with normal
intensity
> Hard braking or braking with ABS
active:
The tail lamps also light up with the
same intensity as the standard brake
lamp units to enhance the warning
effect of the brake lamps.
To Next Page
Loading...
Need help?
General
