9
Configuration Settings Tab Parameters
The way to configure Nyquist appliances is to obtain configuration settings from the
Nyquist server.
TFTP Server Identifies the host name or IP address of the Tr
ivial
File Transfer Protocol (TFTP) server.
The specified TFTP server can be used to automati-
cally set this device’s Configuration settings via the
Get Configuration from Server button.
If TFTP Server from DHCP (see below) is set to “Yes”,
th
is value will be auto-configured via DHCP option
66, assuming the DHCP server has been configured
to provide option 66. For details, see the documenta
-
tion for your DHCP server.
Note: A TFTP server runs on the Nyquist server on
p
o
rt 69 (the standard TFTP port) and the optional
Nyquist DHCP service automatically provides this
T
F
TP address via option 66.
If this value is unspecified, the TFTP Server from
DH
CP will automatically be set to “Yes”, this field will
be
come read-only, and DHCP will be used to config-
ure this setting. To change this value, the TFTP Server
f
r
om DHCP setting must be set to No, which makes
th
e field editable.
TFTP Server from DHCP “Yes” means the device will use the DHCP option 66
value to retrieve an address for the TFTP Server from
DHCP.
“No” means the device will ignore the DHCP option
66
value and use the manually configured value of
the TFTP Server (see above).
DHCP Enabled Indicates if the device is enabled to use DHCP to
re
trieve its IP configuration.
Reboot Appliance Indicates that this appliance should reboot when the
Save button is clicked.
Table 5, Network Settings (Continued)
To Next Page
Need help?
General