11
Digital Call Switch Management
You can assign digital call switches to ports on an ASB via the appliance’s Configuration
Settings tab. If an analog switch was configured as a station with a
type of Digital Call
Switch & Speaker, it will also appear on the Configuration Settings/Digital Call Switch
Ma
nagement page. (Refer to the Managing Stations and Zones section of the E7000
Se
ries System Administrator Guide.)
Multicast # Identifies the IP address, port number, cut level (vol-
ume), and station list used for the multicast audio
st
ream of one (or more) zones.
The following parameters appear for each of the 24 ports associated with the Analog
St
ation Bridge.
Port Number Shows the port number of the Analog Station Bridge.
P
ort Type Shows the device type to which the port connects
(
speaker only, analog call switch and speaker, or digital
call switch and speaker).
Account ID Shows the SIP account (IP address) associated with the
d
evice preceded by the extension of the device associ-
ated with this port.
Local Port Shows the port used for SIP.
U
sername Shows the username or extension for the station associ-
a
ted with the port.
Digital Call Switches Shows by serial number the Digital Call Switch assigned
to the ASB port.
Table 6. Configuration Settings (Continued)
To Next Page
Loading...
Need help?
General