Level Range Selection:
1. Press the POWER button to
turn on the SPLM. The date will
be displayed on the LCD screen
for 2 seconds.
2. After 3 seconds, the screen
enters the default measurement
mode.
7
Calendar Setting:
Setting Date and Clock
Start with the SPLM Unit OFF.
1. While holding down the MAX
CLOCK Button, turn the unit
ON with the POWER button.
2. When the LCD screen flashes
the first digit of the calendar year
(see Figure 2), release the MAX
CLOCK button. Press the LEVEL
UP or DOWN button to adjust the
date. After adjusting the first digit, press the MAX CLOCK button to
adjust the next digit. Press MAX CLOCK to proceed through the date
digits. To adjust the time, continue to follow these steps.
3. When complete, press the MAX CLOCK button once again to exit the
calendar setting mode.
Figure 2
To Next Page
Loading...
Need help?
General